The Advantages Of Hayward Pool Pumps

Since time immemorial the rejuvenating and healing properties of health spas have been known. In countries like Japan where many hot water springs spout out of the volcanic ground attendance at an “Onsen” is a national pastime. Many of these have salts and sulphur and/or other minerals in the water or in the mud and these bath houses lend themselves to relaxation and good health.

Do things in the morning. It is better to do things like cleaning in the morning. Time in the morning is faster than at night. If you will start what you want to do in the morning, you have lots of time in the afternoon and you can do other things during that time.

The operation is much more quiet. A number of things going on with the motor contribute to this. First, a variable speed pool pump’s permanent magnet motor runs with much less vibration than a single-speed induction motor. Second, the motor is totally enclosed (or should be), keeping the noise trapped inside. And the third and most obvious reason, the pumps ability to run at lower speeds reduces operation noise.

Organize your things. Organizing things will definitely save your time. For example, when cleaning your pool, it is better if your pool cleaners are in just one place. On the other hand, other pool supplies like pool safety covers, Palmetto Pool Pumps, heaters and others must be in another place. This way, it will be easy for you to get the pool cleaners whenever you plan to clean your pool.

You can also use a solar pool cover to keep your pool warmer. Even if you live in an already warm climate, this will help retain heat to keep your pool warmer on cloudy days or for nighttime swimming. These covers usually keep your pool around fifteen degrees warmer. If used in addition to a pool heater or pump, they can keep maintenance costs for heating a pool low.

Check for noise. If your pump starts running louder or making noises than usual, then shut it off. Contact your pool professional to assess the condition of your pump.

Check the pH level, which normally lies between 7.4 and 7.6. Increase the pH using sodium carbonate or soda ash. Decrease the pH with muriatic acid or sodium bisulfate. Some pool owners also add clarifiers at this time. Allow another eight hours for chemical circulation. Hyper-chlorinate or shock the pool using one pound of granulated calcium hypochlorite or five gallons of household bleach for every 10,000 gallons of water.

Leave a Reply

Your email address will not be published. Required fields are marked *

Recent Posts
Categories
FREE CONSULTATION
Consultation Banner

Contact Us Today

Contact Form